Shield driver moteur L298P avec GPIO

Description

This is an upgraded version of Arduino Uno L293D Motor Driver Shield, which comes with a lot more features!

This motor driver shield is based on L298P motor driver IC is capable of driving two brushed motor, with speed, direction, start and stop simultaneously. With two full H-bridge circuit, this motor driver shield can also drive bipolar or unipolar stepper motor.

Besides the L298P driver IC, it comes with header pins and female header for GPIO of Arduino. Analog input pins of Arduino Uno (or Mega) are extended with SVG (Signal Voltage Ground) configuration, or the RC servo header pins configuration, making it simple for you to connect to other sensor modules.

Features

• Drive two DC motors at 4.8-24V at up to 2A peak (1.0 continuous max) current
• Built-in Schottky diodes to protect against motor back EMF
• Drive 1 servo motor with a dedicated 5V regulated power
• Built-in buzzer connected to D4, active high type
• Extra push button as Arduino reset switch
• Has bluetooth extension header connector
• Ultrasonic Range Finder Ping socket for SR04 (Ping and Echo)
• RGB LED connector
• 6 analog/digital pins (A0 to A5) brought out to 3-pin headers (SVG) with 5V and GND available for each input for easy sensor hookup
• Stacking female connectors for supporting another daughter card
• Can optionally power attached Arduino off the shield